# Correlating technical terms C073

CORRELATING TECHNICAL TERMS C073

There are a few technical terms that frequently appear in the papers I write along with the formulas I use. These terms include:

- Specific gravity.
- Gravity
- Specific heat
- Specific speed
- Density
- Rpm or speed

If you are going to be messing around with pumps, bearings and mechanical seals, these words are going to have to become a regular part of your vocabulary. In this paper I am going to show you how these words sometimes work together to get us the information we need to both select and troubleshoot centrifugal pumps and mechanical seals. We will start with specific gravity; a measure of the weight of a fluid.

Specific gravity or Density numbers are used to:

- Calculate the pressure, if we know the pump’s head; and calculate the head, if we know the pressure.
- Calculate NPSH available at the suction of a pump, to determine if the pump is going to cavitate.
- Calculate the water horsepower generated by the pump, to help us select the brake horsepower of the motor we need to drive the pump.

Gravity is used:

- When we use the Bernoulli formula to convert the velocity of the impeller, or liquid flow to head. Bernoulli told us that the head in any fluid system is a constant. The head is either in the form of pressure or velocity head.

Specific Heat determines how hot the product will become with the addition of heat. The specific heat numbers are used to:

- Calculate the amount of heat generated inside the wet end of the pump.
- Determine if the stuffing box temperature will be too high.
- Calculate the amount of heat generated at the mechanical seal faces.
- Predict if the product will vaporize at the seal face.
- Predict if the hydrocarbon will coke at the seal face or inside the stuffing box.

Specific speed describes the shape of the pump impeller. We use this number to:

- Determine if our pump is likely to cavitate.
- To help in the selection of an efficient pump.
- To calculate the hydraulic force acting on the impeller as we operate off the BEP.
- To determine the direction of shaft deflection if we are operating off the pump BEP.

Rpm or speed is used:

- To calculate the feet per minute (fpm) at the seal faces to determine if you need to convert from rotating to stationary seals.
- As a part of the force formula we use to calculate the force on an impeller, when the pump is operating off its BEP.
- In the affinity laws, to determine changes in head, capacity and power requirements any time you change the speed of the pump, or the diameter of the impeller.
- To determine the DN number for precision bearings.
- To determine the maximum speed for slurry pumps.

### Category

### Posted

- On February 15, 2018